03. Installing ismartgate in the Gate

Install wireless sensor

Sliding Gate

With a screw-driver remove the screws from the top cover of your wireless sensor.

Place the provided Type N batteries on the sensor and screw the top cover back in.

Hold the wireless sensor with your hand and move the magnet between 0 and 0,2 inches next to the sensor (hold this during almost 5 seconds).

Check if the status yellow light (right) of the ismartgate device blinks faster.

If the Status light doesn´t blink faster, please write us at support@ismartgate.com

1. Place the sensor and magnet where the gate closes. Magnet attached to gate. Sensor to non-moving part (ie. wall).
2. Make sure the magnet is facing the right side of the sensor, where the “Magnet” message is point out to.
3. Magnet and sensor must be no more than 0.2 inches (0.5 cm) away.

Make sure that sensor is in direct line of sight of ismartgate device.  The “Status” light should be blinking faster when door changes position.

If all is correctly placed, let´s test the overall installation.

< Previous
Next >