03. Installing the Sensor in the Garage
Install Magnet (Gate) sensor
Side Sectional Door
With a screw-driver remove the screws from the top cover of your wireless sensor.
Place the provided Type N batteries on the sensor and screw the top cover back in.
It is important to ensure that all 4 screws are tightened correctly to prevent water or moisture from entering the sensor.
Hold the wireless sensor with your hand and move the magnet between 0 and 0,2 inches next to the sensor (hold this during almost 5 seconds).
Check if the status yellow light (right) of the ismartgate device blinks faster.
If the Status light doesn´t blink faster, please write us at support@ismartgate.com
1. Place the sensor and magnet where the door closes. Magnet attached to door. Sensor to non-moving part (ie. wall).
2. Make sure the magnet is facing the right side of the sensor, where the “Magnet” message is point out to.
3. Magnet and sensor must be les than 1.25 inches (3cm) away.
English 
Spanish 
French 
German 
Norwegian 
Swedish 
Dutch 
Danish 
Italian 
Polish 
Turkish